Farmall & IHC Tractors Discussion Board |
Re: Need opinions on long axles on 1066
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by mikeinmo on March 24, 2004 at 17:46:21 from (208.31.189.242):
In Reply to: Need opinions on long axles on 1066 posted by Mitchissippi on March 24, 2004 at 08:25:28:
Maybe you like wrenching more than I do. We have cut several axles on IH's around here. We use a "quickie saw". Gas powered abrasive cut off saw that we use on the job site. Find someone with one of these or rent one, maybe you have one. Get a few blades for cutting steel, not the concrete blades. Takes about one blade for each side. Make a good square cut and then bevel the end with a grinder, add a little black paint and it'll be hard to tell it was ever cut. I have cut four or five sets for neighbors and don't know of any problems from this. Good Luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|