Farmall & IHC Tractors Discussion Board |
Prince Hyd.PTO pump Super A
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don Green on March 17, 2004 at 17:44:40 from (152.163.252.227):
Hi guys,I have a mower drive with a right side output for the pulley.The pto shaft exits the trans below the pulley housing.I was looking at those prince pto pumps and i was wondering if it will slide on the pto shaft far enough beacause it will hit pulley housing.My calculations seem to be it will only slide on about 2 inches before hitting.Anyone using one of these with the mower drive/pulley setup still in place?I dont think it will work.Didnt buy a pump yet beacause of this.I think it is possible i will make junk out of tractor and the pump at the same time-don
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|