Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Valve tappet adjustment
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on March 09, 2004 at 20:11:54 from (207.178.99.121):
In Reply to: Re: Re: Re: Valve tappet adjustment posted by GG on March 09, 2004 at 19:33:37:
Does the 0.017 measurement increase, decrease, or remain the same throughout the compression stroke? From your answer both intake and exhaust are closed (the way I do it) and the dial indicator (if I had one) does not move as the piston goes up. So I will assume your answer is "stays the same" -- only mine varies about 0.003. I know that regardless of which cycle the engine is in, that a closed valve can be adjusted, but does the piston have to be at absolute TDC when the adjustment is made?? Again, from your answer, apparently not as the dial indicator is not supposed to move until the lobe lifts the lifter. At the beginning of the compression stroke, my feeler guage is tighter than at TDC. So is there maybe something wrong with my valve train? -- tractor runs fine. I am adjusting the valves following a valve job.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|