Farmall & IHC Tractors Discussion Board |
Re: Re: What valve config for new 3pt
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Theman on March 09, 2004 at 10:35:24 from (65.248.77.5):
In Reply to: Re: What valve config for new 3pt posted by MM on March 09, 2004 at 07:28:38:
The detent holds the valve spool open until a preset resistance (back pressure) is reached. When your cylinder reaches the end of its stroke, the rise in pressure makes the detent release. The spool automatically returns to the center (off) position. You can pull the lever back to center by hand at any time if you wish. The "release" pressure is usually adjustable - much like a pressure relief valve. If adjusted too tight, it is hard on the hoses and ram seals. If adjusted too low, the valve can shut off before the implement is completely raised. Safety precaution: Don't operate your remote hydraulics from the ground no matter which valve you buy. A knee, arm, or (in my case) a foot could be in the way of all that power. The extra few seconds saved isn't worth it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|