Farmall & IHC Tractors Discussion Board |
Installing starter switch. Wiring assistance pleas
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kurow on February 29, 2004 at 12:18:02 from (202.49.143.34):
Background I have a farmall AV and have installed lights, gen etc. The starter i have is not original and has solenoid as opposed to pull lever. I have installed a "momentarily on" push switch to act as the starter switch. Question. How should this be wired up. Solenoid to one terminal and where should the other go? Next question. How do i test that the generator is actually charging? When i have the lights on (tractor not running) it shows discharge which would seem right. When tractor is running the dial still shows discharge but the needle flicks every now and again. I have a meter. What terminals do i test aginest and what reading should i expect. battery was fully charged when installed. Photo to follow of finished product.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|