Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Starter- Pull or Push ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TimV on February 23, 2004 at 13:13:52 from (12.39.239.130):
In Reply to: Re: Re: Starter- Pull or Push ? posted by John in NE on February 23, 2004 at 13:04:46:
John: I can't speak first-hand about a "B", as I don't have one handy. However, the engine and transmission are identical to the "A", so it can't be that much different. On an "A", the starter contact works off from a small pin mounted on the starter, which swivels to make contact. Depending on how the linkage was configured, this could be either a "push" or a "pull", but in either case, the contacts still need to press together. This would mean that it would be difficult to make THIS PART of the system be a "pull". However, that's only a small piece of the puzzle--the majority of the issue you're dealing with seems to be the actuator rod, not the contact itself. This could be fabricated to make the action either a push or a pull without too much brainwork. From the sounds of it (being that it's made from allthread) it looks like your system is the result of "field expediency", rather than being the original solution. If that's the case, you could re-route and/or re-fabricate a better solution without having to worry about further compromising the originality of the tractor.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|