Farmall & IHC Tractors Discussion Board |
Re: Super H wide front
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Zak on February 20, 2004 at 06:41:06 from (64.12.97.12):
In Reply to: Super H wide front posted by tom on February 20, 2004 at 03:52:24:
I'm gonna put myself on a limb here and say no. I just put a 560 WF on my 300 and the bolt holes are about 1/2" further apart on the 400's front end (same as for M and up) than they are on the narrower H-350 series pedestal. Additionally, the mounting bolts are 3/4" on the bigger series as opposed to 5/8" on the smaller. HOWEVER, this doesn't mean you can't use it! All you have to do is drill smaller holes 1/2" in towards the centers to mount it. OR, as I did, cut the pedestal mounting plate off the bracket on your WFE and make a new plate out of 1/2" steel with the proper moutning holes. Then, just MIG weld it on and you're good to go. You may have rear support mounting issues as well, but I made my own plates there. It all depends on your ability to "make do" with what you have, or sell it and find what ya need! Good luck, Zak
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|