Farmall & IHC Tractors Discussion Board |
Re: Farmall H bore/ belt pulley ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod on February 14, 2004 at 19:00:53 from (64.12.97.12):
In Reply to: Farmall H bore/ belt pulley ? posted by Farm w/Junk on February 14, 2004 at 15:09:54:
Matt: I also have a '46 H Farmall. I tried replacing just the rings as you did but came to find out they would not fit right. So ended up just replacing the whole works.....sleeves, pistons, rings. Even connecting rod bearings since I was in there anyway. The problem is that the set of rings is matched to the piston so many times the rings will not fit or will be to lose on used pistons. There is both a oil seal and a felt washer on the belt pulley shaft. I got both at my CASE/IH dealer with no problem. If you need the original part numbers I can get them to you. I found it easy enough after you take off the whole pulley assembly and work on it at the work bench. It is heavy!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|