Farmall & IHC Tractors Discussion Board |
Re: H 12v alternator?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BIG JOHN on February 13, 2004 at 19:04:36 from (205.188.209.82):
In Reply to: H 12v alternator? posted by Ken on February 13, 2004 at 18:16:58:
It will fit but it is a very tight fit. I have found that using a Hitachi #14231 alternator from a 1980 Nissan 720 pickup is much easier to get into this tight fit. NAPA has them part #2138130 cost $49.49 + core. This alternator is 4 1/2" in Dia. and 7" in length and will go right on the orginal mountings on the tractor. Use an 8" x 3/8" bolt and some pipe for spacers. Being Hitachi means that it is METRIC You will need to drilll out the mountings to 3/8". The tension adjusting bolt is also metric thread. This alternator is a three (3) wire set up which can be easily converted to one (1)wire. There are spade conections labled S & L and a BAT conection. The L spade is for the idot light and can be disregarded. Use a jumper wire from the S spade to the BAT post and your are good to go. The pully is a split type that you can widen using a spacer (once again METRIC). You will need to use a disc type lock washer and some locktite because there won't be room to reuse the split lock washer that comes with it. There is a built in regualtor and a resister to keep the battery from feeting back to the alternator. If you want the alternotor to start charging without having to accelerate the engine you can install a resistor or idot light to feed the L spade. This is a sweet fit under the hood of H's, M's, W's also Cubs and many others. GOOD LUCK
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|