|
Farmall & IHC Tractors Discussion Board |
300U Gas Tank Removal Tricks???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Kirk on February 12, 2004 at 14:11:03 from (170.215.145.91):
I just discovered that my intermittant lack of power is due to poor fuel flow. Tractor quit during snow plowing the other day. The fuel bowl was clean, but with bowl off and valve open all I got was a VERY slow drip......drip......drip. The fuel bowl won't unscrew with the tank in place. It may not be the original, but it hits the casting when I turn it even with all fittings removed. So tomorrow I'll be trying to remove the tank and get it cleaned out. This is my first time "under the hood." My parts book doesn't show fasteners, etc. very well, so I'm wondering whether this is straightforward or tricky. If anyone has experience removing this tank and has found it tricky, I'd very much appreciate hearing the secrets before I start. Or any ideas about the most effective way I can clean the tank. Thanks very much for your thoughts. Bob Kirk
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
