Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Belt Drive Hammer Mill
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB on February 11, 2004 at 19:03:15 from (24.157.143.220):
In Reply to: Re: Re: Belt Drive Hammer Mill posted by SGT K on February 11, 2004 at 07:25:03:
We had a J.I.Case #8? hammer mill for about 50 years. My Dad use to run it with a SC with a 50ft(100ft of belt) endless 8 inch belt that was from the threshing machine. On the SC to turn the hammer mill in the correct direction it had to be a "straight belt" and if there was a cross wind the belt would flap and jump around when there was no load on it. Later when we used B414D the belt pulley coukd be installed to left or right. We would install it to the left for hammer mill as now it required a "crossed belt" to run the proper direction. This eliminated the jumping and flapping caused by the wind and also appeared to provide better grip on the pulleys. Threshing machines were always run with a "crossed belt". Belt dressing is a must. The black tar like stuff that came in a tube was the best. Good luck JB
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|