Farmall & IHC Tractors Discussion Board |
Re: Re: Re: OT building a trailer
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kelly C on February 11, 2004 at 14:02:44 from (63.171.43.140):
In Reply to: Re: Re: OT building a trailer posted by scotty on February 11, 2004 at 03:51:14:
Its 82 inches wide by 16 feet long. The axels are 3500 pound axles each and both have brakes. The axles did save me alot. Got them for what just new tires cost. GVW I guess would be the same as any 7000 pound trailer. I have had my H on it and it pulls fine with that. I wouldnt be afraid to go any where with that. I have also pulled my 400 on it. The 400 wont fit between the fenders and has to sit to far back. And it very heavy for the trailer. I would use it to get to a haying job 15-20 miles tops. If you make one make one that is a deck over the axles. and at least 7 feet wide. 8 feet would be more usefull.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|