Farmall & IHC Tractors Discussion Board |
Re: Should I clean the rocker assembly or leave it
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mr. J on February 04, 2004 at 14:48:14 from (204.184.253.248):
In Reply to: Should I clean the rocker assembly or leave it be? posted by clanger on February 04, 2004 at 14:28:12:
I would definately clean it up. Looks a little carbon and possibly rust coated. I've always used a tub of diesel fuel and a good stiff, yet absorbent, brush to clean hard parts like your rocker arms. The diesel is a good solvent that isn't as flammable as gasoline, and is much cheaper that buying store brand cleaners. Also, I love the smell of that diesel. Another thing to check for is the oiling ports and holes. Make sure that they are not plugged up with anything, and I would suggest using an air compressor to purge those lines and clean out any sludge that may have accumulated over the years. Hope that helps, Mr. J PS: I just had a student bring in a Super 44 Oliver, there were only 750 of those made. It was stuck tight from sitting 14 years in grandpas shed, but, now we've got the pistons and valves out and are looking forward to hearing the little bugger run in a couple of months....Just a little heads up from the Jasper MO agricultural education shop.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|