Farmall & IHC Tractors Discussion Board |
Re: Re: Re: 560 hydrolics slow???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Daddy on February 01, 2004 at 16:56:12 from (209.163.43.180):
In Reply to: Re: Re: 560 hydrolics slow??? posted by RB on February 01, 2004 at 13:48:51:
I went out and tried her again today. Put the kerosene heater under her for about 45 minutes, went out, and gave her a pull. She ran excellent, but still, no hydolic power. I left her run for about 1/2 hour, and then the hydrolics kicked in just as they should. I think that I may end up having to replace the oil again. One more question, with my adjustment lever for the fast hitch, when I pull the lever all the way down {so that the cylinder will be all the way out}, the cylinder comes out all the way, but the pump continues to run. Then, when I push the lever all the way forward {to drop the cylinder all the way down}, the cylinder sticks out a good 2 1/2 inch, and the shaft won't go completly into the cylinder like it should. It worked great when I first got it, and then it started to show the cylinder won't go all the way in, and then the pump will run even when the cylinder is all the way out. Any ideas? Thanks!!
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|