Farmall & IHC Tractors Discussion Board |
Re: 10' Wheel Disk to much for '46 H?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by It depends on January 31, 2004 at 13:38:12 from (64.12.97.12):
In Reply to: 10' Wheel Disk to much for '46 H? posted by Jim on January 31, 2004 at 08:55:48:
Width of disk is just one factor in determining what you can pull. Just as important is diameter and pitch of disk blades, scalloped vs smooth disks, weight on disk and angle of cut. I do not doubt that H will pull 10 ft. under some conditions but where I live H is not going to pull 10 ft. with new scalloped disks with all angle in that is in plowed ground and cutting. They only pull 18 ft. with 150 HP tractors with duals.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fasteners: The Nuts and Bolts of Nuts and Bolts - by Curtis Von Fange. The nuts and bolts of nuts and bolts is an interesting and essential piece of knowledge that applies to our older tractors. An improperly torqued capscrew on an engine head or a shear bolt that is too hard on the driving shaft of a bushog can create havoc and make an expensive and uncalled for repair. Let’s examine the purpose and design of these fasteners in order to ensure their proper use. Fasteners are probably one of the aspects of mechanics that is given the least amount of thought.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|