Farmall & IHC Tractors Discussion Board |
Speed
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne M Kittler on January 31, 2004 at 11:00:54 from (24.194.176.20):
I have never run a tractor higher than second gear except for transporting. That is with mowing, chopping, baling, and plowing. It just seems to me that I do a better job at lower speed and 540 rpm. In the 80's, I mowed with a Ford 501 mower and a B 414 tractor. When I went to repair the worn out engine all I needed to do was replace the rings. Bearing clearance for the crank had not changed on the plastic gauge. I find I wear machines out versus breaking them. Many of you guys talk of mowing 60 acres a day,etc. I realize that to run a commercial operation you must have capacity.But,on a small,stoney acreage and shooting for top yield per unit, should I consider speeding it up for the equipments' sake? I like to sell my older equipment for about what I pay for it, and have been successful this way for 30 years.
Follow Ups:
- Re: Speed James Williams 12:43:49 01/31/04
(0)
- Re: Speed sammy the RED 11:47:06 01/31/04
(0)
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|