|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: 06 vs. 56 vs. 66 series shifting
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 27, 2004 at 13:53:59 from (216.208.58.167):
In Reply to: Re: Re: Re: 06 vs. 56 vs. 66 series shifting posted by rebuilder on January 27, 2004 at 12:57:44:
rebuilder: Over the years right from the ox and the horse days onward there has been a lot of equipment like that. In Atlantic Canada there are still a lot of oxen around mainly just for show. The coast of Maine also has a very active group. Each year they have the International Ox Pull. It is a home and home series. Many of these teamsters are real actors. Of course unlike tractor pulls they work on who ever can move the highest percentage of their team's own weight. They make a pull, then will add 200 or 400 lbs at the discression of the teamster. They will go until the team can not move it. The other item is the Canadians use the Head Yoke and the Americans use the Neck Yoke. I watched a team one night almost falter on a pull. While the crew were loading more weight, the teamster down on one knee, lectures each ox with a verbal oration you would swear was comming from a law professor at law school. Eye ball to eye ball, and when he was done with the second ox he went back to the first ox and said," You are just like dealing with the missus." Of course the promoters move the microphones right in so as to here all this exchange. After the lecture the ox team pulled the load with 400 lbs added and pulled it with ease. I don't know whether that will work with the 806.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
