Farmall & IHC Tractors Discussion Board |
Re: 806 steering problem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on January 25, 2004 at 15:25:11 from (66.163.134.177):
In Reply to: 806 steering problem posted by Craig Rickert on January 25, 2004 at 15:03:02:
Your power steering pump may have lost it's prime. Do you have a TA, and does it work? The same pump supplies both. It's located on LH side of tractor, just behind clutch housing, inboard of the MCV. Is the rear end full of oil? I just went through this with a 706. Actually removed the pump, it looked too good to replace, so I reassembled it with a little petroleum jelly on the gears, then poured some oil in it just before installing on the tractor. Pump worked fine, and pressures checked out. It has been working since last spring. The tractor has not been used much, but has been run occasionally, and continues to build pressurwith no problems. Maybe someone will post with a method to prime the pump without removing it, or perhaps I should have just replaced my pump.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|