Farmall & IHC Tractors Discussion Board |
Re: Re: Re: IH 444 With a Loader--Front Pump Requi
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB on January 24, 2004 at 17:25:44 from (24.157.143.220):
In Reply to: Re: Re: IH 444 With a Loader--Front Pump Required? posted by rcwilbur on January 24, 2004 at 13:22:50:
Hi again, if the loader is plumbed correctly as I described both the loader and 3 pt can be active at the same time. There were other cheaper methods of plumbing the loader where the Remote outlet was used in front of the seat and the ON/OFF valve at the front of the seat was closed. If this method was used then only the loader or the 3pt hitch could be used depending on the valve setting. One of our other neighbors had a 444D with a non IH loader on it and it was plumbed the cheap way. How heavy are your round bales ? Connected to the 3pt hitch pump the 1500 loader will lift about 1500 lbs or more if you add a dime to the relief valve in the loader controls. But unless you have sufficient weight on the rear the rear end will go in the air. Also the front end was not build to stand 2000 lbs. JB
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|