Farmall & IHC Tractors Discussion Board |
Re: Re: How to remove 484 exhaust manifold? (pictu
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by clanger on January 22, 2004 at 17:26:27 from (80.176.149.33):
In Reply to: Re: How to remove 484 exhaust manifold? (picture) posted by JB on January 22, 2004 at 16:30:51:
hi JB, Well I got it sorted. I found a cranked ring spanner that allowed me to get the last exhaust manifold nut off and then the water exit manifold. It was suffering from excessive crankcase breathing and poor starting, but according to the (working) hour meter it's only done 3600 hours. Having taken the head off this evening we found some deposits in #2 inlet manifold and scoring on #2 sleeve, so one of the rings must have broken. Not got sleeves out yet so time will tell. I'm going to grind the valves in and replace the stem seals and hopefully that will do the trick. It only gets used for mowing about 5 acres so it's not heavily used - I just wanted to fix the breathing/dripping oil.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|