Farmall & IHC Tractors Discussion Board |
Re: What would it take to give my Super M live hyd
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on January 15, 2004 at 04:40:56 from (208.59.157.148):
In Reply to: What would it take to give my Super M live hydraul posted by Griz on January 14, 2004 at 19:52:44:
A pump, reservoir and the plumbing. Get a live pump that replaces the distributer drive housing, either factory or an aftermarket like M&W. A reservoir. Either convert the existing belly pump into a reservoir by plumbing a return line from the bottom (some even replace the end plate that has the pump housing with a flat plate to gain a little more) -or- Get the factory reservoir from a tractor with live hyds which mounts under the gas tank and replaces the rear gas tank mount (note you will have to move anything mounted to that mount [ie: regulator, starter switch, choke rod] and move your battery which is typically under the seat on the live hyd models). Good luck, Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|