Farmall & IHC Tractors Discussion Board |
Re: How to slide rear wheels on 1066
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 15, 2004 at 04:04:25 from (216.208.58.182):
In Reply to: How to slide rear wheels on 1066 posted by Vern on January 14, 2004 at 19:35:01:
Vern: One of the items I learned very early on with these big tractors was a pallet jack is very handy. You want to move that heavy wheel, pallet jack. If you want to remove that wheel, set tractor on hardwood pallets, use ratchet straps to anchor wheel to pallet in upright position. Then with jack place the whole wheel right where you want in, might be on other side of shop. To split the tractor for a clutch change, or other , place your pallet under front half of tractor, block with good square blocks to front axle and frame rails, again tie it to pallet with tiedown ratchet straps. I have nerver split a 1066 this way, I would do it though, I have done a 560 diesel and done it without help. Did the 300 once took front end across shop and went back with a second pallet for the torque tube. I don't have the big tractors anymore but still use the jack around the little ones. I can set all my single point implements on pallets, I even have parts bins on pallets. I even have my work bench complete with vise built on a pallet.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|