Farmall & IHC Tractors Discussion Board |
Farmall 350 broken boss on engine block
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy on January 13, 2004 at 07:16:21 from (12.2.73.20):
I have a Farmall 350 and I have been working on installing an external coolant heater to it. I started by trying to remove the drain plug located behind the carburetor. My particular set up had a brass 45 degree street elbow coming out of the engine block and a steel plug in the end of the elbow. In the process of removing the plug from the brass elbow I broke the brass elbow off at the engine block, leaving about a ½” of threads inside the block. I found an Easy Out that would fit the ID on the broken fitting and attempted to use it to remove it. My problem is that it just kept going in until the circular boss that holds the fitting cracked. Now, I’m not sure what to do. First off all, what did I do wrong with the Easy Out? It sure wasn’t that easy. Secondly, and more importantly, what can I do now to fix my predicament? As always, thanks in advance, Andy
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|