Farmall & IHC Tractors Discussion Board |
Re: Finnaly worked on my 300
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ross on January 05, 2004 at 06:41:14 from (208.5.57.66):
In Reply to: Finnaly worked on my 300 posted by Kelly C on January 04, 2004 at 15:10:10:
If the pistons and sleeves look in good enough shape for you go ahead and use them. If you have a good machine shop you trust take the pistons and rings and while your at it the crank and get them mic'ed and get their opinion on them. If it were me though, if you've got to replace things such as the TA and the clutch, in my opinion you may as well go the extra mile spend the extra on the pistons and do it right the first time. Hey it's waited this long and you have the 400 now for the heavy lifting. Conversely if you do have to replace those items maybe you'd want to save a few bucks by just re-ringing not to mention getting into service faster. Either way best of luck, I always get a kick out of the adventures and misadventures on your website. In all honesty I'm a real tight wad, If I could get away with re-ringing I'm not sure I wouldn't go that route myself but I'd hate to see you get that 300 back together and then have problems when the hay's on the ground. Ross
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|