Farmall & IHC Tractors Discussion Board |
Re: F-12 Engine rebuild?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Zak on January 03, 2004 at 16:45:10 from (152.163.252.227):
In Reply to: F-12 Engine rebuild? posted by Kevin (LA-CA) on January 02, 2004 at 16:41:23:
I just finished an F-012 engine rebuild about three months ago so I've been where you are now! Rice Equip. sells all the gaskets you'll need, and yes there is a gasket between the pump and the block. I'd be leery of using RTV or the like instead of the card stock gasket as you'd not want any of that stuff to get into your pump while running. As to you grease fitting...slowly rotate that flywheel until you see a deep hole in the side of it. Your fitting is in there. I'd probably replace it while you're in there. The brass filter...clean it up good and put it on your shelf. You're gonna have too much money into your engine to re-use an old filter. Authenticity is nice to a point, but a clean engine deserves a clean filter. You'll never get everything out of the old one and what's in there will surely find your new bearings. If you'd like a spreadsheet I made of all parts and supplies with costs for my 34' F-12, shoot me an email and I'll get it to ya! Good luck, Zak
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|