Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: SM Disc Brakes -- Pinon Bearing
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave WV on January 02, 2004 at 11:10:04 from (152.163.252.227):
In Reply to: Re: Re: Re: SM Disc Brakes -- Pinon Bearing posted by Keith on January 02, 2004 at 09:33:50:
When IH started using disc brakes some late M's have them. They redesigned bull pinion bearing cage also bull pinion and bearing. The plate I told you to remove to get pinion shaft out is the bearing retainer that holds bull pinion shaft in. The bull pinion bearing cage is bolted behind this plate you can see bolts after plate is removed. If you have to remove the bearing cage you have to remove the bull gear first. But if you just need to replace the pinion shaft bearing you can remove it as stated earlier. Hope this is not to confusing.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|