Farmall & IHC Tractors Discussion Board |
Re: Can you put Farmall M drawbars on an H?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 01, 2004 at 04:08:58 from (216.208.58.139):
In Reply to: Can you put Farmall M drawbars on an H? posted by John on December 31, 2003 at 15:22:32:
John: Your swinging drawbar, should be when in the center position, 15" from end of pto shaft to center of drawbar pin hole. That is what all trailing pto equipment is designed for. Anyone claiming these drawbars can't be switched from one model to another has very limited imagination. Sure there will be some slight modifications and maybe the belly mount on an H is different from a 560. That same U was used on a lot of C, SC for mounting semi mount mowers. There are two different thickness for the U, same was true of swinging tongue. Length of tongue varies also. The C obviously used different axle housing clamps from H or the M. I have a 300 swnging drawbar geared up to fit my Farmall 130, about the only thing I didn't use was the axle housing clamps. My 130 is equiped with one point fast hitch. When using I just drop the pull bar of hitch, mount the 300 drawbar and bingo I'm in business for pto work. I used this on a pto manure spreader for years. This is really not rocket science, most good welding shops could build you and H or M drawbar better than the factory original in the forenoon.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|