|
Farmall & IHC Tractors Discussion Board |
Farmall 560 gas question- aftermarket coil and IH
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by skip on December 31, 2003 at 22:08:14 from (152.163.252.227):
Help needed again...
!. I bought a Carquest "hot" coil part #EC UC-12x,cost $50.19 and resistor # RBR 24036 cost$12.82
Also bought champion spark plugs #502 (D21) and universal wire set, points, condenser, rotor and cap.
The auto store says its a replacement hotter version from stock but coil is almost twice the size. Question is, do I buy a bigger bracket and use it or go to the Case/IH dealer and get stock coil.
2. Bought an air filter from Case dealer and it appears that it is too long. Part #AF808K.
I know I'm going to appear really dumb, but I cant seem to get the old air filter out to measure the two. I unscrewed the circular clamp, dropped the bottom and inner metal part that holds the oil bath. Cant seem to get the filter out. I'm waiting for the service and parts manual to come I ordered from Binder Books, but until then, I'm stumped and dont want to pry anything I'm not sopossed to. Would appreciate any advice on either subject. Thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
