Farmall & IHC Tractors Discussion Board |
Re: Re: Reverse Engineering, 424 Hydraulics
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BlueLite on December 31, 2003 at 20:37:35 from (209.226.180.150):
In Reply to: Re: Reverse Engineering, 424 Hydraulics posted by Bob on December 30, 2003 at 20:05:24:
Thanks Bob sounds OK, e-mail me for the cost of the 2 manuals that are not "Blue Ribbon", and we'll take it from there. On the filter, it has a suction filter in the line that goes to the pump. It's a 1.5 X 7in jobbie, and costs a fortune. There is another small screw type filter that's just before the regulator on the pressure line. That's the one your talking about I think. (On the subject of filters the stainless coffee filters you get for a few dollars might be useful, and they seem to be a few microns finer than on the tractors. Might be a good last resort if you can't find one. You'd have to make it fit somehow and use a larger sq. in. area of mesh to make up for the finer mesh). While I'm doing a tear down, I'll be on the lookout for the problem and if I can fix it I will, but the conversion is a last resort. Thanks.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|