Farmall & IHC Tractors Discussion Board |
Re: HyTran Fluid change.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red ManI on December 26, 2003 at 09:14:04 from (67.27.111.10):
In Reply to: HyTran Fluid change. posted by jason b. on December 26, 2003 at 07:24:00:
I can't remember if there are 2 or 3 drain plugs under the tractor, rear-end, transmission, and TA housing? The hydraulic filter is under the plate (6 sides) on the side of the belly of the tractor on the right-hand side. It is a paper filter, replace it. You fill the hyd, transmission, and rear end through the triangle shaped plate on the operator's platform that is held down with 3 bolts. The fluid checks on the left side of the belly of the tractor, a square plug has a small bolt screwed into it, this is the check plug. Use Case-IH Hytran, if there is much moisture in the system, you may need to change it, run it a few more hours and do it again. Run and drive the tractor enough to get the oil warm before changing it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|