Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: steel wheel ranch rebuilt ta
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by paul on December 25, 2003 at 04:42:14 from (216.114.4.137):
In Reply to: Re: Re: Re: steel wheel ranch rebuilt ta posted by rebuilder on December 24, 2003 at 04:06:06:
Rebuilder.I'm working on a smta.Split was a sucess didnt drop it on my foot after removing seasonal disconnect plate I noticed that the previous owner or some hack welded the lever between the two bolt holes that secure enguaged or disenguaged didnt think to much about it at the time.After removal of ta housing I noticed that the same hack welded arround the ipto seasonal disconnect clutch hub,I would assume to lock it into drive because it worked fine using the hand control before split. will start to dissamble ta housing today and will let you know what I find.Paul.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|