Farmall & IHC Tractors Discussion Board |
Re: Re: farmall M tire swap to 26 inch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by grizzly on December 07, 2003 at 18:41:31 from (64.12.97.12):
In Reply to: Re: farmall M tire swap to 26 inch posted by get some dual hubs and re on December 07, 2003 at 16:50:21:
found some 26" combine tires and wheels they had four holes in the rim for weights, the same as the cast hub on a m. the hub has 5 or6 webs going to the ring that the rim bolts to, i cut the web at the base, towards the center of the hub, as close as posible. [cut with a grinder and cutting wheel or a portable chop saw not a tourch] if no weights bolt together, if weights use all thread [i used grade 3 allthread and i have 5 weights on each side and i realy abuse my m and have had no prob] do a little measuring first it took me about 8 hrs, but it was well worth it i have two m and the other is stock the one with 26"in 3rd is about the same as the factory in first
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|