Farmall & IHC Tractors Discussion Board |
Re: fluid damaged rims
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by terry on December 07, 2003 at 08:24:52 from (67.250.216.7):
In Reply to: fluid damaged rims posted by paul on December 06, 2003 at 18:35:41:
I just repaired a rim that was bad at the valve stem hole. Found a large washer with correct diameter hole, and welded it to rim on the inside, then filled the void on the outside with brazzing also. I did this after sandblasting the rim. I also used JB weld to fill in some areas where there were deep pits. Some experts will say this is a poor way to repair a rim, but my tractor has very limited use. Sometimes you have to tell yourself, this rim isn't any good to me now, and the worst that can happen is it won't be any good to you after you have tried to fix it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|