Farmall & IHC Tractors Discussion Board |
Re: Re: My goal is to restore my H to better than
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Richard Fazio on December 01, 2003 at 05:55:59 from (63.126.80.2):
In Reply to: Re: My goal is to restore my H to better than new posted by CNKS on November 30, 2003 at 20:04:01:
CNKS, I was going to post about worn pins and holes in about everything on my M. From the clutch pedal, to brakes, steering, etc. etc. You actually had the holes built back up and used new pins? I was wondering how to handle it. I was thinking new pins of slightly larger size could be a way to fix it up. I was also thinking of brazing around the holes and re-drilling. What did it cost you to fix the worn holes say in your clutch pedal linkage?
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|