Farmall & IHC Tractors Discussion Board |
Re: IH magneto of Farmall MD
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ja0091 on November 29, 2003 at 09:03:58 from (65.169.88.159):
In Reply to: IH magneto of Farmall MD posted by Dick on November 28, 2003 at 20:47:31:
i think you possibly have two problems. since the MD magneto turns opposite rotation to gas engines, the rotor pinion and drive gear should have the beveled teeth and L mark aligned. you are grounding the magneto coil when you place the screwdriver on the terminal that goes to the intake manifold, then ground the screwdriver. i think you get a spark because at that time the points are open, and you complete the circuit. so, check that you assembled the rotor correctly. if that works, and you still have no spark at low rpm, but it works at higher rpm, the impulse coupling must be defective. i assume you are turning the mag the correct rotation with the drill!!!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|