Farmall & IHC Tractors Discussion Board |
Re: Lift all system in a farmall H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on November 26, 2003 at 12:39:18 from (12.65.43.185):
In Reply to: Lift all system in a farmall H posted by Tim Mc on November 26, 2003 at 11:29:23:
The Lift All is a one way system. The pressure and return use the same line. All three of the ports are supply ports. The lift all actuator rod has three positions. All the way forward is release, which lets the fluid from the cylinder go back to the reservoir. Half way at the latch nob on the rod is hold. It does not lift there, but holds the load up. All the way back is lift. If you want to have a two way system, you must add another control valve. To do that you plumb from one of the supply ports to the new valve. The return from the new valve then goes back to the fill port on the lift all or to the drain on the bottom. Then lock the Lift all rod in the lift position and fluid flows through the control valve and back to the lift all reservoir. Then you pipe from the two ports(one a supply and the other a return) on the control valve to your cylinder. It does not hurt the lift all to lock in lift position when piped like this, as it just circulates externally instead of internally. It circulates through the pump internally all the time anyway.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|