Farmall & IHC Tractors Discussion Board |
Re: crimping
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim was in UK on November 19, 2003 at 11:32:15 from (216.31.64.82):
In Reply to: crimping posted by Charli Joe on November 19, 2003 at 11:17:33:
The type of crimp also depends on the type of terminal that you are putting on the wire. Once you have determined the correct size terminal for the wire, strip the insulation back far enough to allow for the terminal to go on the wire. Generally speaking; the length of the thickness of the cable that you are crimping the terminal on to should be sticking out of the terminal. Then select the correct position on your crimping tool to crimp the terminal onto the cable. Most crimping tools have a color gauge (ie. blue terminal crimped onto cable there will be a blue dot on the crimping tool). Crimp the terminal with the insulator in place. Lots of times, if I have heat shrink available I will slide a piece of heat shrink over the connection and shrink it to the cable and terminal. Hope this helps you out with your wiring project. later days mate, Jim in NM again
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|