Farmall & IHC Tractors Discussion Board |
2250 quick tatch loader
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jeff flaharty on November 18, 2003 at 09:54:36 from (199.253.122.31):
I bought a 584 with this loader last spring. I have used it fairly hard at times in a variety of applications with no problems. This morning I was scooping manure and back dragging the barnyard for a couple of hours with no apparent problem. I parked it facing down hill with the bucket dug in to hold the tractor while I open/closed some panels when I was finished, (I have one of those wonderful parking brakes that no longer works). After remounting, I picked up the bucket and one of the cylinder rods that control the bucket pivot was bent. How did that happen? Where is the best place to pick up a new cylinder and how much should it cost? Thanks in advance, Jeff
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|