Farmall & IHC Tractors Discussion Board |
Re: Re: Re: 53 super m wiring follow up question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on November 17, 2003 at 10:46:04 from (165.170.128.66):
In Reply to: Re: Re: 53 super m wiring follow up question posted by bob murphy on November 17, 2003 at 10:26:39:
You got it Bob - no need for warning light and external regulator with the one wire alternator! However for the ammeter to indicate correctly (i.e. show whether the battery is being charged) wiring should be like this: 1 - From alternator output stud to one ammeter terminal. All electrical loads (ignition switch supply, light switch supply) connect to this same ammeter stud. 2 - From the OTHER ammeter terminal to the starter switch battery stud. (Note: If the ammeter reads "backward" when you are finished simply reverse the connections at the two ammeter terminals) Graphically, simply take the diagram in the link posted above and omit the wiring connected to the #1 and #2 alternator terminals.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|