Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall C Pics
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gary_N_WV on November 04, 2003 at 14:06:58 from (69.43.20.232):
In Reply to: Re: Farmall C Pics posted by David in UT on November 04, 2003 at 13:22:43:
David, I've been trying to take a lot of pictures along the way but there will be too many for a web site, but I figured I could sort and replace as I go along. I've been debating about what size to make the bigger pictures and although they take a long time to load on a slow connection, I'm thinking that I'm going to leave them kinda large and make a note on the thumbnail page that they load slow. Anyone that has had an engine apart knows what all this stuff looks like, but I've been thinking that the larger pictures might make good reference for someone that is new to the inside of an engine etc. I already have some other information on my site in regard to tune up, parts etc but hope to come up with some pictures and information about implements for the C and Super C. I have searched this site and the web a lot trying to find out information and its hard to come up with much...just bits and pieces here and there. I can't remember the exact link to the Farmall(only) pages on my site, but if you go to the link posted below and click on the Farmall folder on the left hand side of the page you will get there. As I say, I've got lots more to do to the pages and will change my mind a dozen times, but you gotta start somewhere. This site, YTMAG is great, but I just kinda thought I'd try to stick some stuff together...all in one spot. Gary
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|