Farmall & IHC Tractors Discussion Board |
Re: Farmall model A head torque numbers
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Kevin (FL) on October 29, 2003 at 19:42:43 from (12.94.105.244):
In Reply to: Farmall model A head torque numbers posted by Mike on October 29, 2003 at 14:50:34:
Mike, On the bolt pattern, just start in the center and work your way outward front and to the rear. I always torque my first set at 10 #'s and then go up in 10 or 15 # increments from there. Might be a little overkill for some, but I've never had a gasket blow for either gas or diesels I've done. As to the torque value, that's based on bolt diameter, thread pitch and grade of the bolt. If your manual says 65#'s then I wouldn't go any higher than 70#'s on the final torquing. I do that anyway as most torque wrenches have a 2 or 3% error. As to the compression pressure, that depends on compression ratio of the engine and the condition of the rings and valves. If that engine has a 7:1 compression ratio then the measured pressure should be about 103 #'s. (7 x's atmospheric pressure, which I think is 14.7 PSI). If it's 8:1 compression then it would be about 117 PSI. and so on...Our AC B model has about 110 PSI pressure, but it's not newly rebuilt. Hope that helps you out.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|