Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Re: International 240 Utility


[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Denver Davis on October 22, 2003 at 18:57:57 from (170.215.137.187):

In Reply to: Re: International 240 Utility posted by Bill Ramsey on October 22, 2003 at 06:26:28:

Though I am still concerned about the coil, it is leaning toward a fuel problem. Think I will make another trip tomorrow evening and drain and clean the fuel tank and fuel bowl.

The plugs carboning up with black soot don't make sense. It seems to me that would not be caused by a firing problem, but by bad fuel or water. When I opened the drain on the carb fuel ran freely with no indication of water. When I pulled the carb there was no water in it.

The coil also has me stumped. Another forum indicated that there should only be one way to hook up a coil, regardless of 6V, 12V, or positive ground. The (+) should come from the switch and the (-) go to the distributor. This coil is marked (bat.) and (dist.), with the (bat.) going to the distributor and the (dist.) coming from the switch. This sounds backwards to me, but it ran fine that way when I went to look at it the first time. I tried reversing it the other night and it did not make a difference, but if that would have an effect, the damage may already be done.

Does anyone know of a way to test the coil with an ohmmeter, say for grounds, shorts or opens?

Again, Thanks for your input.

Denver


Follow Ups:




Post A Followup

:
:

: Re: Re: Re: International 240 Utility

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor. ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy