Farmall & IHC Tractors Discussion Board |
Re: Farmall H and M transmissions questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by john d on October 21, 2003 at 21:36:54 from (205.188.209.82):
In Reply to: Farmall H and M transmissions questions posted by Rick in MD on October 21, 2003 at 12:34:47:
I've got a '49 M that still has lots of the original parts in the transmission and rear end. The engine has been rebuilt and tweaked to far beyond original power output. It was dyno tested after the last re-build at 52hp. We pulled a Moline 4-14 trailing plow with it in 2nd and 3rd gear for years. It's been on the farm since 1952, and I think the only parts in the transmission and final drive that have been replaced were the pilot bearing at the front of the transmission (after lots of years pulling a 3-14 plow in 4th gear!) and the carrier bearings in the final drive, which were upgraded to 560 bearings. If you tear up an M transmission, it's because you ran it out of oil, shifted without the clutch, re-powered it with a huge engine, or didn't fix something when you first heard a strange noise.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|