Farmall & IHC Tractors Discussion Board |
Super A Starting Problem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bama Red on October 19, 2003 at 14:09:57 from (170.215.116.30):
I just tried to start my Super A which has been sitting for six weeks while I recovered from knee replacement surgery. I charged the battery (BTW, the tractor has been converted to 12v. by the previous owner), and tried to start it and nothing happened. Disconnected battery cables and wire-brushed them and battery posts, still no luck - the starter is not even clicking or groaning - I'm sure I'm not geting juice to it, but I don't know why. The wiring job has always been suspect - it is really jury-rigged and sloppy. I have taken a look at Bob M's wiring diagrams and am not sure which one to use to rewire my SA - I do not have a key ignition, just a magneto ignition system, the pull starter rod and the "Out to Run-In to Stop" switch. Anyone got any ideas??? Here's a link to Bob M's wiring diagrams:
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|