Farmall & IHC Tractors Discussion Board |
Re: Re: Hyd routing - pump to spool or res. to spo
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bbauman on October 15, 2003 at 10:46:05 from (166.50.130.188):
In Reply to: Re: Hyd routing - pump to spool or res. to spool? posted by Aces on October 15, 2003 at 10:18:56:
Both of us (SM and SH) have external 2 spool valves so we can run buckets and lift the loader at the same time. You are correct, he can turn off his hydraulics with the resevoir lever and does if he has to hand crank it. I'll never hand crank so not a concern either way. To clarify, my main question is is either way better as far as quickness of hydraulic movement, pressure, etc. My hydraulics hesitate, not sure if its a weak pump or if it is the hose routing. I don't know enough about hydraulics to know if there is more pressure and gpm by going from the resevoir or the pump.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|