|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: SUPER A STILL NOT RUNNING
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bill in vt on October 14, 2003 at 17:18:20 from (198.68.167.141):
In Reply to: Re: Re: Re: Re: Re: SUPER A STILL NOT RUNNING posted by Gary_N_WV on October 14, 2003 at 11:14:15:
Gary,
I really appreciate the time you have taken to answer. I have a couple more questions then I hope to get this resolved! Assuming it is the ignition switch, would that be enough to stop a running engine? Checking the spark at the end of a plug, do I remove any spark plug and hold the firing tip near the engine block (similar to holding the coil wire?). What guage wire should I use to jump the ignition switch with? , if it comes to that. If the rotor is not turning then I assume the distributor shaft gear is stripped and I'll need a new distributor. I have the owners manual so I should be able to set the timing if necessary. On Sunday, when it did quit I checked the points and did not see a spark at that time. I'll let you know how it turns out, hopefully soon! Thanks again.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
