Farmall & IHC Tractors Discussion Board |
Re: Re: Re: how 2 check rod and main bearings?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on October 08, 2003 at 04:53:50 from (208.59.157.94):
In Reply to: Re: Re: how 2 check rod and main bearings? posted by Larry on October 07, 2003 at 20:30:09:
And make sure you only check one at a time, I've had to fix too many with swapped main or rod caps :( Remember that these assy's (either rods or mains) are machined as a pair and the caps are not interchangeable. If you are experiencing any oil pressure problems and it is possible that anyone has worked on your motor in the past, I would check for swapped caps first. The mains aren't marked, check for obvious loosness in the crank (pull on fan belt, and gently pry up on ring gear), the rods should be stamped with matching position numbers on one side of the rod. Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|