Farmall & IHC Tractors Discussion Board |
Re: 1020 engine seized, cylinder sleeve extraction
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Will@ont.ca on October 02, 2003 at 03:08:38 from (206.172.185.168):
In Reply to: 1020 engine seized, cylinder sleeve extraction posted by Greg (TX) on October 01, 2003 at 16:20:41:
Greg,I have freed up two 10-20's that were froze big time and one that was partly seized in the last yr.I tried many methods that were sugested.The most successful way was by putting lub of anykind and everyday give it a few good wacks with a 4x4 hardwood and a 5-10 pound persuader[hammer].Once you get them free they come out the top.There is one other thing you can do to help free the pistons is,once you unbolt them off the crank put a bottle jack and bar of wood or steel and jack up the piston even lifting the tractor off the floor and let it sit all day and ulternate to different pistons each day.Goodf luck!!! Will
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|