Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Setting points on a 48 H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on October 01, 2003 at 18:38:50 from (66.231.125.8):
In Reply to: Re: Re: Re: Setting points on a 48 H posted by I RIGHT I on October 01, 2003 at 17:20:04:
It's hard, nowadays to find a shop that will re-bush a distributor. You might want to check with your CNH dealer to see if bushings are available, and they should not be too tough to install, if you can get them. I don't know about these, but some need to be finish-reamed after installation. A local electric motor repair shop might be able to do that, if needed. The other problem you may run into is bad wear in the advance mechanism in the distributor. I don't know what parts are still available for the advance, and if you find that in tough shape, it might be best to look for a rebuilt distributor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|