Farmall & IHC Tractors Discussion Board |
IHC 300 Utility PTO
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dwight on September 23, 2003 at 15:09:49 from (198.208.223.46):
I have recently picked up a 1956 IHC 300 Utility. Unfortunately, this tractor is not equipped with PTO. It is my understanding that both "dependent" and "independent" PTO were offered on these tractors. I am interested finding out more information about how I might get PTO for the tractor (IPTO would be preferred for the obvious reasons). Does anyone know what a modification like this might involve? Assuming that I could actually find an IPTO unit, could it be as easy as a bolt-on addition? Does the output shaft to drive the PTO actually exist behind the cover plate I have currently (I have yet to check). Or, would I have to deal with more difficult transmission issues? Also, is anyone familiar with parts interchangeability w.r.t. IPTO units. Do I have to find a Utility-based unit? I have seen similar IPTO units on utility and row-crop tractors (with slightly different actuating levers). Any and all information would be appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|